1100 laserprinter (99 Views)
Frequent Advisor
Posts: 55
Registered: ‎06-06-2002
Message 1 of 2 (99 Views)

1100 laserprinter

does anyone have instructions on removing the seperation pad from this printer!!!
i have spent nearly an hour trying to remove the thing!!!
there must be a easy solution to this!!
any suggestions?
problem solving is a nightmare
Posts: 21
Registered: ‎02-19-2002
Message 2 of 2 (99 Views)

Re: 1100 laserprinter

Don't think there is an easy answer to this one. Case has to be removed, then the top plate, then the pickup roller.
After this had been done the separator pads can be removed and replaced. These come in 2 parts the main separator pad and the two little sub pads. Leave the RH pick up roller to last as this can be fitted when all the rest of the machine has been put together.
The whole job should take no more than 30 mins.

Tip. When you have removed the front flap from the case hold it in the closed position with a rubber band.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.